Terry, you are probably onto something here. Apparently, replacement
sills have this hole, and it may be there so they don't have to make two
different panels.
R. Ashford Little II
www.geocities.com/ralittle2
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of twgeiger@hiwaay.net
Sent: Friday, November 08, 2002 1:29 PM
To: TR6 list
Subject: RE: What is this?
In cars that had the dealer installed a/c kit a hole is usually drilled
through
the floor in this general area to allow for the condensate drain line to
exit.
I wonder if the hole you are seeing is where the installer installed an
a/c kit
and chose to drill the hole in the inner seal instead of the floor.
This would
have been a bad thing as the condensate water from the a/c would have
been
deposited inside the inner seal and rocker panel.
One way to tell would to be to look for some unused holes in the bottom
of the
dash where sheetmetal screws would have been. These screws would have
been
needed to attach the a/c unit to the bottom of the dash.
Just a guess....
Terry Geiger
'74 TR6
'79 MGB
> ----- Original Message -----
> From: R. Ashford Little II <ralittle2@mindspring.com>
> To: Triumphs@autox. Net <Triumphs@autox.team.net>; 6-Pack
> <6pack@autox.team.net>
> Sent: Thursday, November 07, 2002 9:23 PM
> Subject: What is this?
>
>
> > I took my carpets completely out of my TR6 recently to let them dry
> and
> > discovered an unusual hole in an inner sill. The pictures are on my
> > website under the link entitled "what is this." The photos are
> taken
> > looking down into the passenger footwall. The hole in question is
> near
> > the front of the inner sill. The pics can be viewed at the link
> below.
> >
> > Thanks,
> >
> > R. Ashford Little II
> > www.geocities.com/ralittle2
|