Cliff,
If you mean the passenger side, front of muffler, mine was a through hole
mount on the back side of cross member that supported the hydraulic
damper/diff. Not very descriptive I know, but look for a hole on the rear
side of the member in the general vicinity of the damper. If yours is like
mint then the previous folks welded a bracket on rather than dig up to the
bolt.
If you want I'll shoot a picture of mine tonight( or maybe sat) and e-mail
it to you.
Steve
1972 TR6 (whose rear hubs go on this weekend)
tr6@kc4sw.com
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of Cliff Davies
Sent: Friday, May 09, 2003 7:27 AM
To: 6pack (E-mail)
Subject: Exhaust hanger question
In an attempt to hang my exhaust system last night
with all the new hardware from TRF
I could not see how or where the rubber strap on
the right side of the muffler attaches.
The car didn't have a hanger at this spot when I
bought it. Presently the body is off,
did it connect to the body?
Thanks
Cliff
|