Ummmm..no, there was nothing in the Pertronix instructions about making any
adjustment. I loosened the nuts and tried to move the plate but there is no
movement; might have to file the slotted hole for more clearance. Is that
little piece of clear plastic the adjusting tool?
Joe
From: shewfamily@aol.com [mailto:shewfamily@aol.com]
Sent: Monday, August 31, 2009 11:44 PM
To: trglory@verizon.net; rmcbride@mi.rr.com; 6pack@autox.team.net
Subject: Re: [6pack] TR6 Dizzy - Part 2
Just checking to make sure you set the air gap between the pickup and the
ring that goes over the lobes. You indicated that you installed it but you
didn't mention setting that gap with the gap tool provided. Just checking.
John Shewmake
'74 TR6 with Pertronics
Birmingham, AL
-----Original Message-----
From: Joe Laurito <trglory@verizon.net>
To: 'Robert McBride' <rmcbride@mi.rr.com>; '6Pack List'
<6pack@autox.team.net>
Sent: Mon, Aug 31, 2009 9:18 pm
Subject: Re: [6pack] TR6 Dizzy - Part 2
Robert;
That sounds like it has possibilities, I'll try it tomorrow. Move the wires
clockwise and turn the distributor counter-clockwise?
Joe
-----Original Message-----
From: Robert McBride [mailto:rmcbride@mi.rr.com <mailto:rmcbride@mi.rr.com?>
]
Sent: Monday, August 31, 2009 9:24 PM
To: Joe Laurito; 6Pack List
Subject: Re: [6pack] TR6 Dizzy - Part 2
I would move all the plug wires one hole on the cap and try again to set the
timing..
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as shewfamily@aol.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|