fot
[Top] [All Lists]

Re: Align Boring for Cam Bearings

To: "Bob Lang" <LANG@isis.mit.edu>, <triumphs@autox.team.net>
Subject: Re: Align Boring for Cam Bearings
From: "DAN DURYEE" <DLDEAD@worldnet.att.net>
Date: Fri, 13 Nov 1998 22:50:46 -0700
Hi Bob,  I had a cam seize in the block several yrs. ago. in the GT-6. I
got
cam bearing from Ken (BFE)  and had them installed here in Denver, cost
was around $250. Most any good engine builder should have a shot -peener.
Dan 
SDS Racing

----------
> From: Bob Lang <LANG@ISIS.MIT.EDU>
> To: triumphs@autox.team.net
> Cc: fot@autox.team.net
> Subject: Align Boring for Cam Bearings
> Date: Friday, November 13, 1998 10:02 AM
> 
> Hi All,
> 
> I'm performing a sanity check:
> 
> TR engine block - align boring for cam bearings...
> 
> I got a price of $375 for the job.
> 
> It sounds high... can anybody provide numbers that support this price???
> 
> Oh, and I'm looking for someone to shot-peen some TR6 rods. Any pointers?
> 
> C ya,
> rml
>
----------------------------------------------------------------------------
---
> Bob Lang              Room N42-140Q          | This space for rent.
> Consultant            MIT Computer Services  |        
> Voice: (617)253-7438  FAX: (617)258-9535     |
>
----------------------------------------------------------------------------
---


<Prev in Thread] Current Thread [Next in Thread>