MIG
--
Tim Davis BN7
> 110 portible wire fed TIG I believe.
>
> Bob Spidell wrote:
>
> >Last question, I promise ;)
> >
> >TIG or torch?
> >
> >
> >bs
> >********************************************
> >Bob Spidell San Jose, CA bspidell@pacbell.net
> >'67 Austin-Healey 3000 '56 Austin-Healey 100M
> >********************************************
> >
> >----- Original Message -----
> >From: "Tracy Drummond" <bighealey@charter.net>
> >To: "Ron Fine Esq." <ronfineesq@earthlink.net>
> >Cc: <Healeys@autox.team.net>
> >Sent: Saturday, June 12, 2004 6:48 AM
> >Subject: Re: Replacing Shock Mounting Plate
> >
> >
> >
> >
> >>Ron,
> >>
> >>Sorry to delay but here are the pics of my shock tower replacement. I
> >>did one side a year ago and this winter
> >>did the whole shooting match. this stood up to some pretty agressive
> >>driving up in Tahoe a few weeks back.
> >>Hope the pics help.
> >>
> >>http://www.wavewired.net/~tracy/suspension/suspension.htm
> >>
> >>Tracy
> >>
> >>Ron Fine Esq. wrote:
> >>
> >>
> >>
> >>>I need to replace the left front shock mounting plate on my BN7 (this
>weekend
> >>>hopefully). There was a very bad repair job many years ago which I
> discovered
> >>>when I tried to replace the shock recently. The existing plate is a mess
>and
> >>>I have a new plate ready to weld on. I will be doing the R&R myself but I
> >>>would like to get any helpful hints on aligning the new plate. The right
> >>>plate is in good shape so I can use it for a guide. I have Norm Nock's
>"Tech
> >>>Talk" which has a simple diagram on page 167. The usual diagrams in the
>shop
> >>>manuals are hard to read even after blowing them up on my copy machine.
>Does
> >>>anyone have any helpful hints or advise (other than "take it to a
> >>>professional")?
> >>>Thanks in advance.
> >>>Ron Fine
> >>>61BN7
|