Ron,
How is the quality of the replacements? Are they complete? Mine are
missing.
Tracy
Rich C wrote:
> Each is fastened to the iner wheel arch with 4 phillips truss head
> self tapping sheet metal screws. Then there is a bottom strap held to
> the splash shield with a 10-32 posi drive pan head machine screw. The
> other end of the strap fastens to the lower outer bolt in common with
> the grille assembly and the radiator duct assembly. Quite a sandwiched
> affair!
> Rich Chrysler
> ----- Original Message ----- From: "Ron Fine Esq."
> <ronfineesq@earthlink.net>
> To: <Healeys@Autox.Team.Net>
> Sent: Saturday, October 02, 2004 3:22 AM
> Subject: Attachment of splash shield
>
>
>> The splash shields on the inside of the front wheel wells on my BN7 were
>> missing. I purchased two new ones which are predrilled with matching
>> holes
>> but I don't know what was used to attach them to the inner fender. Pop
>> rivets, screws, nuts and bolts, ??? Any help is always appreciated.
>> Ron Fine
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|