Larry Varleys incredibly useful website is
www.acmefluid.com.au/larry/
one of the articles is on the TIG welding of the Austin-Healey
shrouds. In it they describe the alloy used.
-Roland
On Sun, 6 Nov 2005 10:29:53 -0600, you wrote:
::
::Thanks, Roland. Good info. What is Larry's website address for the list.
::Sounds like a good resource.
::The repair that I need to make is on the flanges, so no bending required.
::To make compound curves, I would think a softer alloy may be a better
::choice.
::
::Frank
|