healeys
[Top] [All Lists]

Re: "Works" hardtop badge

To: Michael Salter <michaelsalter@rogers.com>,
Subject: Re: "Works" hardtop badge
From: Earl Kagna <kags@shaw.ca>
Date: Thu, 04 May 2006 12:59:43 -0700
Michael:

I agree with your measurements - just went and checked.  My badges are 
definitely original, and are mounted to my original BJ8 hardtop - no key 
ring loop is present.  It was my understanding that the key fob repros are 
the only repros  that have been done to date - (David Ward may know more 
about this than I).  The originals have a rather 'dished' cross section - 
they never did fit completey flat to the top.  I have seen the key fob 
repro, and it looked pretty good to me - I'm sure that they've been used in 
place of the originals with the key ring loop removed.

As you (and others) may be aware, there were 2 'bend over' tabs soldered to 
the back of the badge in the form of a 'u' shaped fitting, which were 
inserted into 2 holes drilled in the shell of the top and bent over to 
secure the badge.  The headlining material (when it was used) was then glued 
to the inside of the shell to hide the badge attatchment point.  Reprodution 
badges could simply be affixed with emblem tape, as is done today.

I hope I don't get swamped with requests, but I can e-mail photos of the 
badge area of my hardtop to those who may have an interest.

Earl Kagna
Victoria, B.C.
BT7 tri-carb
BJ8

----- Original Message ----- 
From: "Michael Salter" <msalter@precisionsportscar.com>
To: "'David Ward'" <david@bighealey.ltd.uk>; <healeys@autox.team.net>
Sent: Thursday, May 04, 2006 9:33 AM
Subject: RE: "Works" hardtop badge


Interestingly I have what I believe is an original of this badge, but has a
rectangular loop on the top to attach it to a key ring fob.
The key ring fob itself is the cheapest nastiest red plastic item you have
ever seen.
The badge is 25 mm wide and 30 mm high not including the key ring loop.
I was of the understanding that a reproduction of this key fob has been
made.
Anyone know if a> This is the original badge?
b> If repros have been made?

Michael Salter




<Prev in Thread] Current Thread [Next in Thread>