healeys
[Top] [All Lists]

Re: [Healeys] High rpm's

To: "Healey Mail List" <healeys@autox.team.net>
Subject: Re: [Healeys] High rpm's
From: "Leonard Hartnett" <thehartnetts@earthlink.net>
Date: Fri, 6 Jul 2007 16:06:45 -0700
Rich:  There is something you can try yourself if you have an adventuous 
spirit.  Reference to an article by Frank Filangeri back in 2004 gave 
instructions to replace a .2 uf capacitor ($2.00 at Radio Shack for a 
two-pack back then) and then adjust the pot to calibrate the tach.

The capacitor, according to Frank's article, "...would be a tubular device 
about 3/8" diameter X 5/8" long probably reddish or black in color. 
Unsolder or clip out the old one and solder in the new.  No polarity to 
worry about, either direction will do.  If this turns out to be the problem 
and the tach appears to work, it must then be calibrated.  There is an 
adjusable pot on the back of the circuit board with a small screwdriver slot 
facing the inside of the back of the tach case.  I drill a 1/2" hole in the 
tach case at that location so I can access the adjustment with the unit 
fully asembled.  Reconnect in the car then just compare it to a known good 
tach/dwell meter and slowly adjust the pot to read the same at 1000, 2000, 
and 3000 rpm.  Tape over the hole when done to keep out dust and moisture.".

For a more detailed article on the electronic tach's operation and repair, 
go to  http://www.classictiger.com/techtips/motach.html .  There you will 
find an article titled,  "Smiths Tachometer Calibration and Repair" written 
by Mark Olson.  (This was on a different Sunbeam Tiger web site when I was 
referred to it by The List back in 2004).  You will get technical, 
disassembly, a schematic, troubleshooting, and calibration, information in 
that article.

When my tach started reading incorrectly, I used these documents to replace 
the capacitor and adjust the calibration pot.  I am far from and 
electical/mechanical expert but I am willing to give things a try.  I was 
successful that time.  As they say,  If I Can Do It, Anyone Can Do It. 
(Even a Caveman?  Oops!  Cavemen don't like that!)

(The Other) Len
Vacaville,  California,  USA
1967 3000 MKIII, HBJ8L39031


----- Original Message ----- 
From: <RAntal243@aol.com>
To: <Healeys@autox.team.net>
Sent: Friday, July 06, 2007 7:04 AM
Subject: [Healeys] High rpm's


> Greeting Healeyphiles,
>     While cruising last night at about 70mph in my  BJ8,  I noticed that 
> the
> rpm's were consistently around 4400 while OD was  engaged. This seems to 
> me
> to be significantly higher than usual. What rpm should  one expect at 
> those
> speeds and if I am correct and the number is uncommonly  high, what could 
> be the
> cause?
> thanks much.
> rich antal
_______________________________________________

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

<Prev in Thread] Current Thread [Next in Thread>