healeys
[Top] [All Lists]

Re: [Healeys] Redi-sleeve install

To: Stephen Hutchings <s.hutchings@rogers.com>
Subject: Re: [Healeys] Redi-sleeve install
From: john spaur <jmsdarch@sbcglobal.net>
Date: Tue, 22 Mar 2011 15:05:48 -0700
I believe Hylomar works great under compression between two flat 
parts but I don't think it would make a good filler sealant which is 
what you might need in this application. Just a guess on my part though.

John, BT7

At 02:39 PM 3/22/2011 -0400, you wrote:
>I'm putting a redi-sleeve over the rear axle shaft where the oil 
>seal rides, and the instructions say to use a non-hardening sealant 
>inside the sleeve before sliding it over the shaft. I thought of 
>using Hylomar, but I thought I'd heard somewhere that people used 
>lock-tite in this application.
>What does the collective wisdom of the list say?
>
>Stephen, BJ8
>_______________________________________________
>Healeys@autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation  $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net
>
>__________ Information from ESET Smart Security, version of virus 
>signature database 5976 (20110322) __________
>
>The message was checked by ESET Smart Security.
>
>http://www.eset.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>