healeys
[Top] [All Lists]

Re: [Healeys] Pressure relief valve

To: Robert Blair <rnbmail@yahoo.com>
Subject: Re: [Healeys] Pressure relief valve
From: Bob Spidell <bspidell@comcast.net>
Date: Sun, 01 May 2011 19:52:22 -0700
I expected the higher cold pressure, too.  What I didn't expect was higher hot 
at idle, because the valve should be 
fully closed (shimmed spring or not).

Bob


On 5/1/2011 6:16 PM, Robert Blair wrote:
> Result is what I would expect - 70 cold should not a problem, but dont run it 
>at 4krpm till it warms a bit.
>
> A coil spring exerts a pressure proportional to the compression.  So by 
>compressing the spring more when seated, you require a higher pressure to move 
>it of the seat.  You are simply moving its operationg point up the pressure 
>curve.
>
> Ideal 3k rpm hot would be 55ish, 1k idle hot would be 35ish.
>
> Robert N. Blair  Yellow 65BJ8  RNBmail@yahoo.com
>
*******************************************************************
Bob Spidell           San Jose, CA            bspidell@comcast.net

*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>