healeys
[Top] [All Lists]

[Healeys] BN1 Hood configuration

Subject: [Healeys] BN1 Hood configuration
From: ahbn6 at verizon.net (John Sims)
Date: Thu, 04 Aug 2011 17:49:41 -0400
References: <1312476665.79418.YahooMailNeo@web87003.mail.ird.yahoo.com> <003701cc52d7$2fbeee30$8f3cca90$@net>
Posted on the Body section of the Technical page.

John Sims, BN6
Aberdeen, NJ
 
http://www.healey6.com


-----Original Message-----
From: Rich Chrysler [mailto:richchrysler at quickclic.net]
Sent: Thursday, August 04, 2011 2:49 PM
To: 'Rich Chrysler'; 'STEPHEN CUSS'; healeys at autox.team.net
Cc: ahbn6 at verizon.net
Subject: RE: [Healeys] BN1 Hood configuration


Stephen,

There are 3 slightly different hood bows within the range of the BN1. The
first had simple pivot points where the arms connect to the anchor plates.
The second had somewhat elongated slots in the one pair of irons so they
could slide and pivot more freely. The third has that slot in the arms
opened up into about a 120 degree L shape so the top assembly could slot
down and recess back further aft to allow better clearance between folded
assembly and the seat backs. Yours will likely be the second series though
possibly the 3rd. It's not clear when one was superseded by the other.

Here are some pictures showing the second series with the small slot. This
is from a July 13/54 BN1. Note also both the first series and this series
uses the single screw per side with trim washer that enters in through the
top material right on the rear dart seam, pierces through the grey webbing
strap inside and anchors into the hole in the rearmost hood bow.

Pictures of the 3rd series to follow.

Listers please note: I am sending this all to John Sims in case he wishes to
post this with pictures to his site, so please don't all ask me for
"pictures please"

<Prev in Thread] Current Thread [Next in Thread>