Re: [Healeys] Clutch/Release/Pressure Plate Questions <mailto:healeys-request@autox.team.net?subject=unsubscribe> <mailto:healeys-request@autox.team.net?subject=subscribe>

[healeyguy@aol.com]

Specific to your question regarding pressure plate bolt patterns, the 9 and
9-1/2 inch pressure plates use the same 10-5/8 inch bolt circle. The pattern
matches. The 10 inch is the odd ball as it uses a 11-9/16 inch bolt circle and
larger bolts.
Your dowel assumptions shown below are correct.
Aloha
Perry



-----Original Message-----
From: warthodson <warthodson@aol.com>

So now I am re-confused.
This seems to indicate that there are three different pressure plate bolt
patterns as follows:
1. BN1/ BN2/BN4/BN6 (9" diameter) with 2 alignment dowels
2. BN7/BT7/BJ7 up to 29F-H4878 (10" diameter) with 2 alignment dowels
3. BJ7 from 29F-H4879/BJ8 (9.5" diameter) with 3 alignment dowels
Correct?
_______________________________________________
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys