[Healeys] bending exhaust down pipes

[john spaur <jmsdarch@sbcglobal.net>]

I need to adjust my pre-shaped exhaust down pipes and I have access 
to a hydraulic pipe bender. I have experimented a little and when I 
bend a pipe it does not seem to go in the direction I would expect it to go.

Are there any trade secrets or tricks to figuring out how to get a 
pipe bent a few degrees in a predictable direction?

Thank you,

John Spaur
San Jose, CA
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys