David
You seal one end by welding plate- pack very tightly with dry sand, the seal
other end the same way. Then with oxy/acetylene torch heat till red and bend
away
Good luck
Cheers
John Rowe Qld Australia
BN1 BT7
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of David Lodge
Sent: Monday, 12 November 2012 4:07 PM
To: Jackson Krall
Cc: healeys@autox.team.net
Subject: Re: [Healeys] bending exhaust down pipes
Not sure if the pipe has to be heated or not. I'll give it a pop one of
these
days!D
--- On Mon, 12/11/12, Jackson Krall <jackson_krall@yahoo.com> wrote:
From: Jackson Krall <jackson_krall@yahoo.com>
Subject: Re: [Healeys] bending exhaust down pipes
To: emmgeeteecee@yahoo.co.uk
Cc: healeys@autox.team.net
Date: Monday, 12 November, 2012, 6:02
David
Ive been aware of the sand technique for a long time and have always wanted
to
try it. I read somewhere that its the way the "bundle of snakes" header on
Jim
Clarks 65 Indy Lotus Ford was fabricated.
Best
JK
------------------------------
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|