Mike, I have a Craftsman 2-3/16" socket (3/4" drive) that I modified to fit the
octagonal hub nut (photo attached). You are welcome to use it for the cost of
postage to and from. I also have some written procedures that I put together
for removing and replacing the rear hub bearing.
As far as the torque is concerned, there is no published value for torque on
the nut that I am aware of. I tighten as much as possible manually, then give
the wrench a couple medium whacks with a hammer before bending over the locking
washer.
Steve Byers
HBJ8L/36666
BJ8 Registry
AHCA Delegate at Large
Havelock, NC
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Michael
MacLean
Sent: Tuesday, September 05, 2017 9:29 PM
To: Healey List
Subject: [Healeys] 2 3/16 Hub Nut Socket
Where can I get a 2 3/16th hub nut socket for the 8 sided axle nut? I also
understand this nut should be torqued down to 180+ ftlb of torque.
Mike MacLean
Sent from Yahoo Mail on Android
<https://overview.mail.yahoo.com/mobile/?.src=Android>
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
Image removed by sender.
Virus-free.
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
www.avg.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170906/9a812abc/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.jpg
Type: image/jpeg
Size: 350 bytes
Desc: not available
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170906/9a812abc/attachment.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Hub nut socket.jpg
Type: image/jpeg
Size: 149078 bytes
Desc: not available
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170906/9a812abc/attachment-0001.jpg>
|
