healeys
[Top] [All Lists]

[Healeys] 2 3/16 Hub Nut Socket

Subject: [Healeys] 2 3/16 Hub Nut Socket
From: cjerryadams at yahoo.com (cjerryadams at yahoo.com)
Date: Wed, 6 Sep 2017 18:25:41 -0500
References: <912466892.3589130.1504661357469.ref@mail.yahoo.com> <912466892.3589130.1504661357469@mail.yahoo.com> <00f001d32723$e9ec6a40$bdc53ec0$@rr.com>
Forgot to mention that the socket I had made was similar to the factory tool in 
that it has a pilot shaft built into the tool. It was drilled so I could use a 
long bar to remove and tighten back up. 

Sent from my iPhone

> On Sep 6, 2017, at 10:22 AM, BJ8Healeys <sbyers at ec.rr.com> wrote:
> 
> Mike, I have a Craftsman 2-3/16" socket (3/4" drive) that I modified to fit 
> the octagonal hub nut (photo attached).  You are welcome to use it for the 
> cost of postage to and from.   I also have some written procedures that I put 
> together for removing and replacing the rear hub bearing.
> As far as the torque is concerned, there is no published value for torque on 
> the nut that I am aware of.  I tighten as much as possible manually, then 
> give the wrench a couple medium whacks with a hammer before bending over the 
> locking washer.
>  
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> AHCA Delegate at Large
> Havelock, NC 
>  
>  
> From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Michael 
> MacLean
> Sent: Tuesday, September 05, 2017 9:29 PM
> To: Healey List
> Subject: [Healeys] 2 3/16 Hub Nut Socket
>  
> Where can I get a 2 3/16th hub nut socket for the 8 sided axle nut?  I also 
> understand this nut should be torqued down to 180+ ftlb of torque.
> Mike MacLean
> 
> Sent from Yahoo Mail on Android
>  
> <image001.jpg>
> Virus-free. www.avg.com
>  
> <Hub nut socket.jpg>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/cjerryadams 
> at yahoo.com
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20170906/eacb68e9/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>