Replacing the seal with the windshield in place will qualify you for a
"Master Magician title"
On 5/30/2018 9:42 AM, Tom wrote:
> I'd like to replace rubber gasket between the windshield and body on
> my BJ8.
>
> From the archives, the job looks like a PITA.? Is this job normally
> done with the windshield in place, and I slide the new seal in a
> little at a time?
>
> Or should I remove the windowshield/frame from the car and install the
> new seal?? It looks like the windshield frame attaches to the body
> with three bolts on either side...? would removing the windshield from
> the car, putting the seal in place with the windshield off, then
> putting the whole thing back on be easier?
>
> thanks,
>
> Tom
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180530/c1ce8750/attachment.html>
|