mgs
[Top] [All Lists]

Re: Aluminum heads

To: larryhoy@prodigy.net, mgs@autox.team.net
Subject: Re: Aluminum heads
From: REwald9535@aol.com
Date: Wed, 24 May 2000 00:55:44 EDT
Larry,
Good question.  Here is what happens.  The thread chaser (chaser not tap) has 
four relief's cut into the threads from the tip back along the shank.  When 
running the chaser through the hole dirt and debris is deposited into the 
channels.  When removed the debris can be scraped off with your fingernail, 
or a shop rag.  Typically no metal is removed from the head during the 
process, only dirt and debris.  If the threads are thrashed to the point that 
the thread chaser won't go in or threads are missing then it is time for a 
thread repair kit (heli-coil or equiv.).  When using these products metal 
will be removed from the head, but again most if not all is kept in the tap.  
Type A personalities may at their option put grease on the tap to trap more 
of the shavings.  The rest of figure that once the new plug is in place and 
the piston comes up on the exhaust stroke the first time any residue will be 
blown into the front muffler. 
Rick

In a message dated 05/23/2000 9:32:07 PM Pacific Daylight Time, 
larryhoy@prodigy.net writes:

> Hey Rick, answer this.  When you chase the head threads isn't there a 
danger 
> of ending up with
>  fine metal parts in the cylinder?  Is there some trick to this?

<Prev in Thread] Current Thread [Next in Thread>