oletrucks
[Top] [All Lists]

RE: [oletrucks] balance resistor

To: "'Perry Smith'" <perigrinefalcon@netscape.net>, oletrucks@autox.team.net
Subject: RE: [oletrucks] balance resistor
From: "Hanlon, Bill" <Bill.Hanlon@COMPAQ.com>
Date: Mon, 15 Nov 1999 11:02:36 -0600
Make sure the diode is beefy enough.  You are going to be pulling 
~ 6 Amps through it when the points are closed and there is 
going to be a really ugly spike when the points first open and the 
field starts to collapse in the coil.  

-----Original Message-----
From: Perry Smith [mailto:perigrinefalcon@netscape.net]
Sent: Monday, November 15, 1999 10:24 AM
To: oletrucks@autox.team.net
Subject: [oletrucks] balance resistor


Hi all 
 Thanks for the responses, in reply to the question of replacing the
resistor,
yes, twice. What I have been able to determine since my last post is that
the
by-pass wire that I installed is allowing the resistance in the solenoid
coil
to pull down the voltage to less than 1.5 volts (I still have a closed
circut
through the primary terminal and the low voltage side of the resistor). Not
enough to power the coil. I am now looking at installing a diode in the
by-pass wire, electricity flows only one way thru a diode. If that dosn't do
the trick then its out with the old and in with the new, providing there's
enough clearance with the firewall.

Perry Smith
'58 GMC Fleetside
Phoenix, Arizona

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>