Countersunk. I found a 1 1/2" wood bit I plan to use. I've seen it suggested
to use a hole saw and chisel but that sounds tougher than just the wood bit.
EEHodges@aol.com
48 Chevy 3/4 ton "Rack"
In a message dated 11/23/1999 11:16:07 PM Eastern Standard Time,
Mikecdk@aol.com writes:
<< Well I'm at the point of bolting together the new oak wooden bed in the
back
of my 66 stepside. Does anyone happen to know if the offset washers are
supposed to sit on top of the wood? Or are they to be countersunk so they
are flush with the surface? An old piece of plywood was in the truck to
begin with so I have nothing to go by.
Appreciate any help!
Thanks!
mike >>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|