This works very nicely, but be completely prepared, and don't waste time
once the hot part meets the cold part, or they will stick and then you have
a big problem.
53 GMC 1/2T
From: G. Simmons <email@example.com>
To: firstname.lastname@example.org <email@example.com>
Date: Tuesday, May 30, 2000 4:22 PM
Subject: Re: [oletrucks] RE: spindles
>I once got a tour of the Edelbrock plant in Torrance, CA. I was interested
>to learn that when they install the valve seats in their aluminum heads,
>they freeze the seats as well as heating the heads.
>If you had the spindle off the truck (perhaps during a front end rebuild),
>you could do the same thing to buy a couple thousandths. Put the spindle
>the freezer and put the disk adapters in the stove.
>54 3100 (getting there)
>54 3100 (waiting to get there)
>55 1st 3100 (not much there)
>Los Angeles, CA
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959