oletrucks
[Top] [All Lists]

Re: [oletrucks] Backing plate

To: bmdumkee@auroranet.nt.ca, oletrucks@autox.team.net
Subject: Re: [oletrucks] Backing plate
From: MKlepp4335@cs.com
Date: Fri, 29 Sep 2000 13:34:05 EDT
In a message dated 9/28/00 7:38:30 PM Central Daylight Time, 
bmdumkee@auroranet.nt.ca writes:

<< My only thought at this time is to get the welder at work to cut/grind this
 piece from one and weld it on the other. Any thoughts on this idea? >>

Is the diameter big enough to drill and tap so it could be bolted throught 
the backing plate?  Welding would likely be the stronger choice, especially 
if the bolt were less then 5/16".  

Mike Klepp
'48 3100
Wichita Falls, TX
http://www.geocities.com/mike_klepp/septruckpage.html
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>