The stoplight switch is mounted on the firewall below the steering column.
It has a lever that is activated by the brake pedal mechanism. It has two
wires, one of which goes to the original firewall mounted fuse box. (it is
most likely covered with grime and hard to recognise).
Larry Kephart
1955 1st 3100 Chevy (BillyBob)
1991 Jeep Wrangler (Renegade)
Boca Raton, Florida
e-mail: webmaster@laroke.com
http://www.laroke.com/larryk4674/1998/billybob.htm
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of 50chevy@iwon.com
Sent: Monday, April 02, 2001 5:17 PM
To: OleTrucks List
Cc: Sam.Barrette@mail.oasd.k12.wi.us
Subject: [oletrucks] Electrical Wiring
All,
I just finished installing a Chevy Duty $100 harness in my '50 3100 and
it was really simple. Plenty of color-coded wire and good instructions.
My only problem came from the replacement headlight switch I had to install
at the same time. It doesn't have a terminal for stoplights, and I can't
figure out where to hook the wire up.
Any comments or suggestions would be appreciated.
Ray Wright
'50 3100 12volt
--
iWon <http://www.iwon.com/> - Voted the #1 portal on the Web!
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|