Elbow "grease". Seriously, I had the same problem (if you can call it a
problem; probably protected the frame better than anything could, for the
times). I chiseled & wire brushed A LOT. There may be a better way, but I
don't know what it is.
Regards,
Doug Pewterbaugh
dpewter@msn.com
Denton, TX
49 3104 216 5-window
----- Original Message -----
From: "Mark A. Self" <mark.self@verizon.net>
To: "Oletrucks mailing list" <oletrucks@autox.team.net>
Sent: Wednesday, May 23, 2001 9:56 PM
Subject: [oletrucks] Road tar removal
> Trying to clean the underside of the AD's floor. Fair amount of really
> tough road tar. Blaster doesn't remove this stuff very well. Short of
> chiseling it off, is there some kind of chemical that will loosen/remove
> this stuff?
>
> ======================
> Mark Self
> '55 1st 5 window 3100
> Redlands, CA
> mark.self@verizon.net
> "Sentimental Journey"
> ======================
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|