My '77 also has a square hole but doesn't that piece
spline onto the steering shaft?
Dave Gebhard
----- Original Message -----
From: Mostrom, Paul <Mostrom.Paul@principal.com>
To: <jmcneal@ohms.com>; <spitfires@autox.team.net>
Sent: Tuesday, April 11, 2000 12:29 PM
Subject: RE: Steering Wheel Interchangability
My '77 has a square hole where the steering wheel
connects to the steering
shaft. I believe that it's been discussed before on
the list that this is
different than the earlier models. Don't know about
the '78 - '80 models.
Thanks,
Paul Mostrom
'77 Spitfire 1500
> '80 Ford F-100 (Triumph Support Vehicle)
>
>
'Black holes, where God divided by zero......'
-----Original Message-----
From: SJagGo@aol.com [mailto:SJagGo@aol.com]
Sent: Tuesday, April 11, 2000 11:48 AM
To: jmcneal@ohms.com; spitfires@autox.team.net
Subject: Re: Steering Wheel Interchangability
Hi Jeff,
You wrote,
"I'm selling an aftermarket leather
steering wheel I pulled from my '67 Mk3 on The Totally
Triumph Auction and
I've received a couple of e-mails asking whether it
will fit later model
Spitfires. I'm assuming that the hubs on all Spitfire
models were
interchangeable. Am I correct or in error?"
The 62-76 Spits and all GT6's will interchange for
sure. 77 and up I'm not
sure, as the upper steering column became part of a NSS
(Not serviced
separately) unit and also the retaining nut changed
numbers. They look
similar, but I haven't removed one.
Bill Brockschmidt
|