spridgets
[Top] [All Lists]

Re: Hydraulic Line for CLutch

To: thistle_3619@yahoo.com, spridgets@autox.team.net
Subject: Re: Hydraulic Line for CLutch
Date: Tue, 23 Oct 2001 17:26:01 EDT
In a message dated 10/23/2001 4:39:54 PM Eastern Daylight Time, 
thistle_3619@yahoo.com writes:


> . Any ideas and help would be
> appreciated. Also recommendations on running and
> routing of the line would help.
> 
> 

Jim:

If you don't use a flexible section of line between the master and the slave, 
put a loop in the line.  That way it will flex instead of bend when the 
engine torques.  The bending will eventually break the line.

--David C.



<Prev in Thread] Current Thread [Next in Thread>