[Top] [All Lists]

Re: pressing piston pins

To: Rick Sorak <HTPC@midsouth.rr.com>
Subject: Re: pressing piston pins
From: "K. Valentine" <kevin@valentinephoto.net>
Date: Fri, 24 Feb 2006 18:43:07 -0500
Cc: spridgets@autox.team.net
Delivered-to: mharc@demo.fatchancegarage.com
In-reply-to: <314249905.20060224171928@midsouth.rr.com>
References: <314249905.20060224171928@midsouth.rr.com>
Reply-to: "K. Valentine" <kevin@valentinephoto.net>
Sender: owner-spridgets@autox.team.net
On Feb 24, 2006, at 6:19 PM, Rick Sorak wrote:

  Anyone here installed piston pins? Can I just put the pins in the
  freezer and the rods in a 250 degree oven and then carefully push
  them in?

Best bet is to take them to your local machine shop and have them do it. It should only cost a couple of bucks and they may even do them while you wait.

Kevin V.

Your messages not reaching the list?
Check out http://www.team.net/posting.html

=== Help keep Team.Net on the air
=== http://www.team.net/donate.html

=== unsubscribe/change address requests to majordomo@autox.team.net or try
=== http://www.team.net/cgi-bin/majorcool
=== Other lists available at
=== http://www.team.net/mailman/listinfo
=== Archives at http://www.team.net/archive
=== http://www.team.net/the-local
=== Edit your replies!

<Prev in Thread] Current Thread [Next in Thread>