[Top] [All Lists]

Re: Block flaw?

To: Joe Lansing <kidjoevid@yahoo.com>
Subject: Re: Block flaw?
From: Bill McLeod <wbmcleod@cox.net>
Date: Sun, 26 Feb 2006 14:19:50 -0700
Cc: Spridgets <spridgets@autox.team.net>
Delivered-to: mharc@demo.fatchancegarage.com
In-reply-to: <20060226205318.27863.qmail@web33213.mail.mud.yahoo.com>
References: <20060226205318.27863.qmail@web33213.mail.mud.yahoo.com>
Reply-to: Bill McLeod <wbmcleod@cox.net>
Sender: owner-spridgets@autox.team.net
User-agent: Thunderbird 1.5 (Macintosh/20051201)
It's the cast hole for..... call it equalizing.... pressures, liquids, fingers etc. One side is smooth because the face is machined after the block is cast.
Regards, Bill

Joe Lansing wrote:
When I removed the
timing gear and chain I found a hole that passes
completely through the block, from the smooth machined
side behind the chain to the inside. I've taken a picture available at

Is this normal and functional, or do I have a flawed
or damaged block?

Joe Lansing
62 Sprite.
Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to majordomo@autox.team.net  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

<Prev in Thread] Current Thread [Next in Thread>