[Top] [All Lists]

Re: Block flaw?

To: Joe Lansing <kidjoevid@yahoo.com>
Subject: Re: Block flaw?
From: Frank Clarici <spritenut@comcast.net>
Date: Sun, 26 Feb 2006 16:15:14 -0500
Cc: Spridgets <spridgets@autox.team.net>
Delivered-to: mharc@demo.fatchancegarage.com
In-reply-to: <20060226205318.27863.qmail@web33213.mail.mud.yahoo.com>
References: <20060226205318.27863.qmail@web33213.mail.mud.yahoo.com>
Reply-to: Frank Clarici <spritenut@comcast.net>
Sender: owner-spridgets@autox.team.net
User-agent: Mozilla/5.0 (Windows; U; Windows NT 5.0; en-US; rv:1.4) Gecko/20030624 Netscape/7.1 (ax)
Joe Lansing wrote:

When I removed the
timing gear and chain I found a hole that passes
completely through the block, from the smooth machined
side behind the chain to the inside. It is not
This hole is on all 1275s, very similar to the hole in the center web under the center main bearing carrier.
I think they used a hammer to make these holes.
It's for oil flow. Do NOT plug it up ;)
Frank Clarici
Toms River, NJ

Your messages not reaching the list?
Check out http://www.team.net/posting.html

=== Help keep Team.Net on the air
=== http://www.team.net/donate.html

=== unsubscribe/change address requests to majordomo@autox.team.net or try
=== http://www.team.net/cgi-bin/majorcool
=== Other lists available at
=== http://www.team.net/mailman/listinfo
=== Archives at http://www.team.net/archive
=== http://www.team.net/the-local
=== Edit your replies!

<Prev in Thread] Current Thread [Next in Thread>