[Top] [All Lists]

Re: [Spridgets] Crankshaft Spigot bearing removal

To: "WJHS1960" <WJHS1960@comcast.net>, <spridgets@autox.team.net>
Subject: Re: [Spridgets] Crankshaft Spigot bearing removal
From: "Larry Daniels" <ladaniels@sbcglobal.net>
Date: Wed, 5 Sep 2007 18:03:48 -0500
I just measured one of my ribcases -- 1/2" on the input shaft.

Larry Daniels

----- Original Message ----- 
From: "WJHS1960" <WJHS1960@comcast.net>
To: <spridgets@autox.team.net>
Sent: Wednesday, September 05, 2007 5:49 PM
Subject: Re: [Spridgets] Crankshaft Spigot bearing removal

<<But wouldn't it be the same as the I.D. of the
aforementioned bearing?>>

Yes Pat, BUT most "shadetree mechanic" situtions do not allow for having a
caliper for measuring something THAT small (5/8" and smaller).  BUT that 
a drift should be the same size as the rib-caged tranny input shaft which
Daniel says he does not have.

So the answer he is looking for would be a drift either 11/16s or 5/8s" or
9/16s or 1/2s", I beleive.

I also do not have an input shaft to measure.  Perhaps someone DOES have
either or both handy to measure correctly?!?!?

Edit your replies



<Prev in Thread] Current Thread [Next in Thread>