spridgets
[Top] [All Lists]

Re: [Spridgets] Sleeving master/brake cylinders - Stainless vs.

To: tequila.brad@gmail.com, dlh2001@comcast.net
Subject: Re: [Spridgets] Sleeving master/brake cylinders - Stainless vs.
From: Weslake1330@aol.com
Date: Thu, 19 Jun 2008 06:36:45 EDT
Hi Brad,
 
Off work today sick with a stinking cold - had to go to bed at 8pm  yesterday 
as I was too tired to stand up.
 
I've just been through a series of clutch issues and replaced everything  
before pulling the engine.  Things to try are using an extended clutch push  
rod 
(it can help you get enough clutch travel even with poor hydraulics).   The 
slave on the early minis is much the same as the spridgets (but you might  need 
to check this).  Stay away from silicone brake fluid.  Fit a  rigid pipe from 
the slave bleed long enough to appear in the engine bay and then  put a 
fitting on it so you bleed from this point.
 
Hope you can sort this before LOTO.
 
Regards
 
 
Daniel 
 
In a message dated 19/06/2008 02:51:26 GMT Daylight Time,  
tequila.brad@gmail.com writes:

I wish,  I already put a nut in the slave cup, to lengthen the clevis. No joy
What  is the real pisser, is that this master DID work, for about two  days,
before it shit out all the fluid. I get it reworked, and it blows out  the
slave. I buy a slave, and it STILL won't F'n work. Damn near $400,  for
shit.....
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>