spridgets
[Top] [All Lists]

Re: [Spridgets] Bearings Replacement

To: spridgets@autox.team.net
Subject: Re: [Spridgets] Bearings Replacement
From: BJNoSHOV8 <bjshov8@tx.rr.com>
Date: Sat, 12 Mar 2011 22:14:31 -0600
Generally if you don't have rod knock and if your oil pressure is good 
with a good gauge, then the bearings should be doing fine for now.  If 
you were racing the car then you might want to know that your bearings 
are in better shape.  You could also switch to a thicker oil to help 
with this.  If you are getting much bearing material flaking into the 
oil then eventually you would start to hear rod knock or you could see 
your oil pressure drop when the engine is hot and at low engine speeds.

On most engines, once you pull the oil pan off then you have access to 
all of the bearings.  (Sometimes the big battle is actually getting the 
pan off.)

You should have easy access to all of the rod bearings.  Once you pull 
the nuts/bolts from the bottom of the connecting rod then the rod cap 
and lower half of the bearing will come off, and you can move the crank 
and push the piston up to get more room to access the upper half of the 
bearing.  You can wipe off the bearing and look at it, and feel of the 
crank journal to see if it is smooth or not.  You can also buy some 
platigage and check the clearance between the bearing and the crank journal.

You can't easily lower the crankshaft although that would be possible if 
you really had to, but you can pull off the main bearing caps and the 
lower half of the bearing should come off with it.  You can inspect the 
bearing and the crank journal, and do the plastigage thing if you wish.  
On most engines it is simple to replace the bearings too.  Most bearings 
have a tab that fits into a slot in the block, to keep the bearing from 
rotating.  So with the main cap off the upper half of the bearing will 
rotate out one way but not the other.  It is easy enough to use the new 
bearing shell to push out the old bearing shell, just get the tabs in 
the right place.

We used contact cement to stick the gasket to the pan.  This is to hold 
it in place, not actually seal it.  It does the sealing on its own.  In 
the old days we didn't have RTV but there were other sealers that could 
be used between the side pan gasket and the front and back gaskets.  Now 
RTV would be the thing to use, just put a dab at the joint between the 2 
gaskets then put the pan in place.

>       Do I read this to say that the #1 and #2 mains might be inspected or
> changed without pulling the engine. If so, then how would this be done? It`s
> been a long time, but I seem to recall that the mechanics in the shop where I
> worked got the lower main shells out by just dropping the cap.Then I think
> they used a small tool to somehow hold or push out the upper main shells as
> they turned the crank.
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>