[Top] [All Lists]

Re: [Spridgets] Axle issue

To: "Pat Elliott" <pelliott@innercite.com>, "'Spridget List'" <spridgets@autox.team.net>
Subject: Re: [Spridgets] Axle issue
From: "Nelson Wittstock" <k8djc@zoominternet.net>
Date: Sun, 15 Sep 2013 04:39:51 -0000
Authentication-results: smtp02.armstrong.synacor.com smtp.mail=k8djc@zoominternet.net; spf=fail; sender-id=fail
Authentication-results: smtp02.armstrong.synacor.com header.from=k8djc@zoominternet.net; sender-id=fail
Delivered-to: mharc@autox.team.net
Delivered-to: spridgets@autox.team.net
References: <005101ceb19d$b94cc100$2be64300$@innercite.com>
X_cmae_category: 0,0 Undefined,Undefined a=Pe9Lv4nJWijhx71bm9CLlw==:117 a=Pe9Lv4nJWijhx71bm9CLlw==:17 a=K-v-2zaBAAAA:8 a=KMUqRZBTGbEA:10 a=8nJEP1OIZ-IA:10 a=_VnqN573AAAA:8 a=B_bPcynLLlAA:10 a=RpJsd_eKXV7yX6xmRigA:9 a=wPNLvfGTeEIA:10
I just recently went through the same thing.  I lost track of how many times 
it moved back and forth but just a little bit.  Being able to knock it out 
from the inside of the diff was a major challenge.  None of my punches were 
able to reach through to the broken off piece.  Finally I found a small 
diameter rat tail file that would make contact with the axle piece.  I just 
kept beating the piece out a little and then back in.  Then all of a sudden 
it was laying on the floor.  In the process about an inch of the file broke 
off but at that point it was worth losing it.  I gave a lot of thought to 
just giving up but then what would I do.  All I can say is just keep doing 
what you have been doing and I wish you luck.



Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>