Re: [Spridgets] Racer guys Engine help

[derf <derf247@gmail.com>]

And as with all A-series tuning one should set the valve lash before
starting carb adjustment, right?



On Mon, Jul 21, 2014 at 12:33 PM, Glen Byrns <grbyrns@gmail.com> wrote:

> Am I the only one who has never seen a valve adjuster screw drilled for oil
> passage? Mine, on both forged and pressed rockers are solid.
>
> Sent from my iPad
>
> > On Jul 21, 2014, at 9:33 AM, Tim Collins <thcollin@mtu.edu> wrote:
> >
> > Lester,
> > No doubt that you are checking the condition of all the other
> adjusters?? If
> the push rods were wrong for one, the Might be wrong for all, but then
> again .
> . .
> >
> >
> > At 12:59 AM 7/21/2014, Lester wrote:
> >> Bob, I found both pieces, it broke right at the area that is necked for
> oil
> >> passage.
> > ------------------------
> >
> > spridgets@autox.team.net
> ------------------------
>
> spridgets@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
>
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/derf247@gmail.com
------------------------

spridgets@autox.team.net


Archive: http://www.team.net/archive