spinning wheel stud

["Janssen, Lee K" <lee.k.janssen@lmco.com>]

After removing a spinning wheel stud on the front hub of my TR6 I noticed
that the hole is enlarged to the point where the new stud does not generate
a tolerance fit. As a result if I insert a new stud it will only be a matter
of time before it too will start spinning. Since a new hub is $190 I was
wondering if anyone has a way to cure this problem.
If a new hub is in order is it the same as the TR4 since I know of someone
with a parts car.
Thanks in advance
Lee