Jack,
I think the correct adjustment procedure for gross jets is to add
spacers to the threads which effectively lowers the ball.
Regards,
Joe
Jack R. Clark wrote:
>
> Listers,
> Rebuilding carbs and installing grose jets. It appears that the float
> extension arm depresses the metal ball enough to close off the valve
> without any adjustment. I adjusted a little so that the arm exerts a little
> extra pressure. Is this needed, is it best not to adjust at all. I do not
> want to have a lower than required amount of fuel in the float chamber, but
> then again I would hate to see it flood. Any advice other than trial and
> error?
>
> Thanks,
> Jack 74TR6 cf23352
--
"If you can't excel with talent, triumph with effort."
-- Dave Weinbaum in National Enquirer
|