TR6: Carb Rebuild

["Jack R. Clark" <drjclark@mindspring.com>]

Listers,
Rebuilding carbs and installing grose jets. It appears that the float
extension arm depresses the metal ball enough to close off the valve
without any adjustment. I adjusted a little so that the arm exerts a little
extra pressure. Is this needed, is it best not to adjust at all. I do not
want to have a lower than required amount of fuel in the float chamber, but
then again I would hate to see it flood. Any advice other than trial and
error?

Thanks,
Jack 74TR6 cf23352