| To: | The Brinkers <mbrinker@flash.net> |
|---|---|
| Subject: | Re: TR6 Bonnet Latch Adjustment |
| From: | Joseph Sholtes <joeiv@concentric.net> |
| Date: | Tue, 15 Sep 1998 21:03:04 -0400 |
| Cc: | triumphs@Autox.Team.Net |
| References: | <01bddf80$00e41f00$a8dac2d0@brinker> |
Mike,
Besides the rubber bumpers at the rear corner of the bonnet
being too high, you may have too much sping tension at the post.
The post (in the hood part of the latch) is adjustable via the screw
slot in its concal end.
Adjust everything so the hood just, lightly pops open when the release
cable is pulled, as this prolongs the life of the cable.
JOE IV
TR 250
WALLINGFORD, CT USA
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: TR6 Woes Cont'd, Michael Ferguson |
|---|---|
| Next by Date: | RE: TR4/4A Differences, Tony Rhodes |
| Previous by Thread: | Re: TR6 Bonnet Latch Adjustment, Brian Kemp |
| Next by Thread: | Engine Rattle, Ed Woods |
| Indexes: | [Date] [Thread] [Top] [All Lists] |