| To: | Joe Flake <flake@a3115jmf.atl.hp.com>, TR Newsgroup <triumphs@autox.team.net> |
|---|---|
| Subject: | RE: TR6 fuel pump |
| From: | Gary & Priscilla Klein <gklein@toad.net> |
| Date: | Tue, 31 Oct 2000 17:46:29 -0500 |
Joe, The fuel pump valves are held into their recessed area via light crimps in the housing. If you're sure the valve is just fine, then use a small punch to carefully bend the casting over the valve in 3 locations, about 120 degrees apart. Be certain that it's in the opposite way from the other valve before crimping. You have nothing to lose. Save the new pump for the future. Gary '75 TR6 Digest Severn, MD President, TRiumphs Around the Chesapeake, TRAC |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Triumph Model Question, Bob Labuz |
|---|---|
| Next by Date: | RE: Inertial Fuel Cutoff Switch, Jim Altman |
| Previous by Thread: | TR6 fuel pump, Joe Flake |
| Next by Thread: | RE: GT6 Cylinder Head interchangeability, Barry Schwartz |
| Indexes: | [Date] [Thread] [Top] [All Lists] |