Re: To Rebore or Not To Rebore... That is the question!

["Philip E. Barnes" <peb3@cornell.edu>]

At 11:29 AM -0500 2/24/04, Mike Himelfarb wrote:
>Advice needed gang......
>Do I need to rebore?  I'm already figuring to hone the bores because
>I'll be needing rings but am worried about boring as I'll need new
>pistons and the $$'s will increase significantly.  Advice?

It might be more meaningful to get a proper bore gauge and measure 
the bores top to bottom. This would give you information about taper 
in the bores (not unusual) or if they are egg-shaped.
-- 
Phil Barnes (peb3@cornell.edu)
Cortland, NY (nowhere near New York City)      
'71 TR6  CC61193L (27 year owner)