> Any thoughts on the caster discrepancy?
How much is it out? Which direction? Any chance the upper A-arms are not
assembled properly? For the early type (0 caster) arms, the front arm on
the right overlaps the rear arm; but on the left side it's the rear arm that
overlaps.
You can probably get a fraction of a degree change by moving the upper pivot
on its bolts. Beyond that, it's either replace the distorted piece, or bend
the frame, or install custom pieces.
ISTR it was Herman van den Akker that reported finding a bunch of distorted
vertical links; which I think might show up as incorrect caster (and/or
camber). The upper A-arms can also sometimes crack such that it's not
immediately obvious.
Also, as I'm sure you know, 62 was the crossover year for the trunnions. If
someone accidentally installed the wrong trunnion (which would take a fair
amount of force I suspect), that might show up as incorrect caster as well.
-- Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|