triumphs
[Top] [All Lists]

[TR] TR4A overdrive transmission

To: "'Randall'" <tr3driver@ca.rr.com>, <triumphs@autox.team.net>
Subject: [TR] TR4A overdrive transmission
From: Creig Houghtaling <creig555@live.com>
Date: Sun, 24 Aug 2014 07:35:00 -0500
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
Thread-index: Ac+/l9C0Wwc6S6iyTxOC8cA3sfD4bw==
I am restoring a TR4A.  Before I put the OD 4-speed transmission back in the
car, I thought I would check it out for functionality.  I put a 1/2" drill
driver on the input shaft and turned it.  Engaged each gear and saw
different RPM and reverse out the back without any scary noises.  So the
transmission seems OK.  I put 12 volts through the solenoid circuit and saw
the solenoid move the arm at the appropriate second, third, and 4 gear
positions.  But when I spun the input of the trans, I didn't observe any
change in the output of the drive shaft when the solenoid was engaged or
disengaged.  Just as I sat down to write this note I figured out that I need
to check the oil level.  Perhaps even drain and replace the oil.  I haven't
looked at my book yet for recommended oil.  90 weight?

Is there anything else I can check or do prior to installing other than
getting someone to rebuild it?  (Presuming some addition of oil gets the OD
to engage.)

Creig
Creig Houghtlaing 314-401-7817
St. Louis Triumph Owners Association
www.sltoa.org

** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>