- 1. [6pack] Engine Stand Help (score: 1)
- Author: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>
- Date: Wed, 27 Feb 2008 14:36:11 -0500
- --==1184148115== Content-Type: text/plain; charset="windows-1250" Content-Transfer-Encoding: 7bit I just assembled my cheapo Harbour Freight, hope I only have to use it one time, engine stand. I'm su
- /html/6pack/2008-02/msg00276.html (8,063 bytes)
- 2. Re: [6pack] Engine Stand Help (score: 1)
- Author: "Foster, Stan" <stan.foster@hp.com>
- Date: Wed, 27 Feb 2008 19:48:09 +0000
- Bob, when I did this I just spread the attachment arms of the engine stand out at roughly 10, 2, 4 and 8 o clock and then bolted them each to the nearest hole on the rear plate. Note that you will no
- /html/6pack/2008-02/msg00277.html (8,352 bytes)
- 3. Re: [6pack] Engine Stand Help (score: 1)
- Author: tr6taylor@webtv.net (Sally or Dick Taylor)
- Date: Wed, 27 Feb 2008 13:17:13 -0800
- Bob--You'll ned to have the engine back plate in place to mount the arms of the stand. "Better" stands may have more radii choices, but mine is like yours. As Stan noted, you won't be able to remove
- /html/6pack/2008-02/msg00278.html (8,167 bytes)
- 4. Re: [6pack] Engine Stand Help (score: 1)
- Author: Ed Bratt <bratt@sasktel.net>
- Date: Wed, 27 Feb 2008 16:57:12 -0600
- --==0256742234== Content-type: text/plain; format=flowed; charset=windows-1250; reply-type=original Content-transfer-encoding: 7bit Bob: I have been building a Seven replica (for a few years), and an
- /html/6pack/2008-02/msg00285.html (8,129 bytes)
- 5. Re: [6pack] Engine Stand Help (score: 1)
- Author: Greg Perry <rgperry@earthlink.net>
- Date: Wed, 27 Feb 2008 20:33:23 -0600 (GMT-06:00)
- Ed Bratt brought up a good point about using spacers between the stand mount and the engine block. I use 3/8" galvanized pipe nipples over the bolt and a flat washer at each end. Greg Perry ________
- /html/6pack/2008-02/msg00291.html (7,125 bytes)
This search system is powered by
Namazu