- 1. Re: [TR] Run out conclusion. -Related question (score: 1)
- Author: <cfisher@borgwarner.com>
- Date: Mon, 17 Mar 2008 09:01:48 -0400
- I checked my hubs because of the shimmy problem and found the right front to have over .055" runout. My question is how best to true it. I asked a machinist at work about chucking on the inside of th
- /html/triumphs/2008-03/msg00421.html (7,882 bytes)
- 2. Re: [TR] Run out conclusion. -Related question (score: 1)
- Author: tom white <tswhitez123@hotmail.com>
- Date: Mon, 17 Mar 2008 14:34:13 +0000
- Hi Curt, Do not use a die grinder to try and true your hubs. There is no way you can set a tolerance with a freehand grinder. Any good auto fabrication machine shop will be able to do it for you on a
- /html/triumphs/2008-03/msg00423.html (9,029 bytes)
- 3. Re: [TR] Run out conclusion. -Related question (score: 1)
- Author: pethier@comcast.net
- Date: Mon, 17 Mar 2008 17:25:07 +0000
- I believe he is correct. You need more support and a longer axis for location. If I had a large lathe and lots of time, I'd machine a fixture that would locate/hold the hub by the counterbores for bo
- /html/triumphs/2008-03/msg00432.html (10,617 bytes)
- 4. Re: [TR] Run out conclusion. -Related question (score: 1)
- Author: "Randall" <tr3driver@ca.rr.com>
- Date: Mon, 17 Mar 2008 11:20:17 -0700
- I think you guys are making this harder than necessary. Remove the studs & the seal, then mount the hub on the spindle and pull the bearings up to no clearance. Spin the hub and mark with chalk to f
- /html/triumphs/2008-03/msg00434.html (8,679 bytes)
- 5. Re: [TR] Run out conclusion. -Related question (score: 1)
- Author: <cfisher@borgwarner.com>
- Date: Mon, 17 Mar 2008 15:48:55 -0400
- I'll stop at a machine shop on the way home and suggest Randall's idea below, sounds very do-able. Thanks for the suggestions. " To do it on a lathe, put in the inner races then mount the hub between
- /html/triumphs/2008-03/msg00438.html (7,911 bytes)
This search system is powered by
Namazu