- 1. 1098 Midget exhaust sealing tips? (score: 1)
- Author: Unknown
- Date: Wed, 6 Nov 2002 10:46:07 +0100
- Good Morning Listers, Two exhaust queries today: 1/ Any tips for sealing the joint between the exhaust and exhaust manifold? Under the clamp mine was covered in some sort material ("Gun Gum" ?). Is t
- /html/spridgets/2002-11/msg00097.html (8,035 bytes)
- 2. Re: 1098 Midget exhaust sealing tips? (score: 1)
- Author: Unknown
- Date: Wed, 06 Nov 2002 06:32:44 -0600
- The 1098 clamp I have consists of the two semi circular pieces and two bolts. I have not had an issue with odor from under the bonnet. But in all honesty, I drive with the hood removed, so no odor wo
- /html/spridgets/2002-11/msg00098.html (8,811 bytes)
- 3. Re: 1098 Midget exhaust sealing tips? (score: 1)
- Author: Unknown
- Date: Wed, 6 Nov 2002 05:33:56 -0800 (PST)
- "Mehr, Louis" <louis.mehr@sonyericsson.com> wrote:Good Morning Listers, Two exhaust queries today: -- Do you Yahoo!? HotJobs - Search new jobs daily now /// unsubscribe/change address requests to ma
- /html/spridgets/2002-11/msg00099.html (7,237 bytes)
- 4. Re: 1098 Midget exhaust sealing tips? (score: 1)
- Author: Unknown
- Date: Wed, 06 Nov 2002 10:19:43 -0500
- Just to chime in with my .02 cents, I agree 100% with Peter's suggestions. You will only have success with the original setup on your car if the pipe flange is clean and uniform without any bent edge
- /html/spridgets/2002-11/msg00103.html (8,428 bytes)
- 5. Re: 1098 Midget exhaust sealing tips? (score: 1)
- Author: Unknown
- Date: Wed, 6 Nov 2002 11:39:26 -0800
- Ditto everything below, especially making sure the pipe flange is not warped, kinked, bent, distorted etc. If you remove the manifold or have a spare, you can gently hammer the flange against the lip
- /html/spridgets/2002-11/msg00116.html (9,397 bytes)
- 6. Re: 1098 Midget exhaust sealing tips? (score: 1)
- Author: Unknown
- Date: Wed, 06 Nov 2002 16:33:16 -0500
- Louis, I have had success using the moss clamp, clean the flanges and use a jack with slight upward pressure and tighten the clamp. It's not a perfect seal but I haven't noticed any noise or fumes. D
- /html/spridgets/2002-11/msg00118.html (7,682 bytes)
This search system is powered by
Namazu