Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Fitting\s+Shut\s+Face\s+Finisher\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Fitting\s+Shut\s+Face\s+Finisher\s*$/: 3 ]

Total 3 documents matching your query.

1. Fitting Shut Face Finisher (score: 1): Author: "Ron Fine" <RonFineEsq@earthlink.net>; Date: Sun, 27 Nov 2005 17:58:54 -0800; I have almost completed the interior of my BN7. I just have to fit the new Shut Face Finisher sets. The two bottom pieces seem straight forward but the vertical piece needs to be trimmed along the ou; /html/healeys/2005-11/msg00624.html (7,005 bytes)
2. Re: Fitting Shut Face Finisher (score: 1): Author: "Rich C" <richchrysler@quickclic.net>; Date: Sun, 27 Nov 2005 22:37:33 -0500; Basic rule of thumb here is to have the edge of the aluminum follow the profile of the rear fender exactly parallel but just in far enough that the screw heads for the fender flange are covered by t; /html/healeys/2005-11/msg00628.html (8,342 bytes)
3. RE: Fitting Shut Face Finisher (score: 1): Author: "Ron Fine" <RonFineEsq@earthlink.net>; Date: Sun, 27 Nov 2005 21:21:25 -0800; Thanks Again, Rich. Ron, Basic rule of thumb here is to have the edge of the aluminum follow the profile of the rear fender exactly parallel but just in far enough that the screw heads for the fender; /html/healeys/2005-11/msg00631.html (7,500 bytes)

Current List: 1 - 3
Page: [1]