- 1. Last Seat Slide (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Sat, 5 Nov 2005 17:40:58 -0500
- The nuts holding the outboard drivers side seat slide to the floor pan appear to be covered by muffler insulating board and the outboard muffler. Removing the muffler without destroying it seems to b
- /html/healeys/2005-11/msg00106.html (7,096 bytes)
- 2. Re: Last Seat Slide (score: 1)
- Author: "Rich C" <richchrysler@quickclic.net>
- Date: Sat, 5 Nov 2005 18:01:12 -0500
- There should be access holes in the insulation board lining up with the sleeve nuts of the seat tracks. If not, someone has replaced the board with a home made thing and you're on your own. Any curr
- /html/healeys/2005-11/msg00108.html (8,161 bytes)
- 3. Re: Last Seat Slide (score: 1)
- Author: "Mark and Kathy" <mgtrcars@galaxyinternet.net>
- Date: Sun, 6 Nov 2005 09:46:43 -0500
- In case no one mentioned. Not to be an alarmist but I believe that insulation board is ASBESTOS so care needs to be taken when removing. I guess you need to hold your breath for the 2 hours that it t
- /html/healeys/2005-11/msg00119.html (8,185 bytes)
- 4. Re: Last Seat Slide (score: 1)
- Author: Jackson Krall <jackson_krall@yahoo.com>
- Date: Sun, 6 Nov 2005 08:56:43 -0800 (PST)
- In order to keep the lighter than air fibers from entering the atmosphere, the insulation board should be incapsulated using paint, or at least water, before removing or disturbing. Best, JK -- Mark
- /html/healeys/2005-11/msg00129.html (8,498 bytes)
This search system is powered by
Namazu