Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Problems\s+with\s+a\s+Smitty\s+BN1\s+installation\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Problems\s+with\s+a\s+Smitty\s+BN1\s+installation\s*$/: 6 ]

Total 6 documents matching your query.

1. Problems with a Smitty BN1 installation (score: 1): Author: "David" <dcrawfor@san.rr.com>; Date: Wed, 18 Jan 2006 18:55:23 -0800; Esteemed Listers, Here's the condition: We are installing a Smitty's 5 speed conversion kit mated to a Toyota W58 transmission into my '54 BN1. We're using a Toyota throwout bearing and assembly made; /html/healeys/2006-01/msg00621.html (8,137 bytes)
2. Re: Problems with a Smitty BN1 installation (score: 1): Author: Awgertoo@aol.com; Date: Wed, 18 Jan 2006 22:06:34 EST; I did the conversion while at Smitty's shop (emergency basis), reused the BN1 clutch with no problems and drove the car back to Maryland. I later put in a BJ8 diaphragm clutch which is much smoother; /html/healeys/2006-01/msg00622.html (7,814 bytes)
3. Re: Problems with a Smitty BN1 installation (score: 1): Author: "mnhealey" <mnhealey@gmail.com>; Date: Wed, 18 Jan 2006 21:36:07 -0600; Can you shorten the slave cylinder pushrod? I'm not sure if that'll help or not, but I think it might. Cc Curtis L. Carlson MAHC Membership Director/Newsletter Publisher PO Box 6844 Minneapolis, MN 5; /html/healeys/2006-01/msg00623.html (7,313 bytes)
4. RE: Problems with a Smitty BN1 installation (score: 1): Author: "Tracy Drummond" <bighealey@charter.net>; Date: Thu, 19 Jan 2006 06:10:08 -0800; I ran into a similar issue with my BT7 conversion. I was sure I was to have Clutch slip forever. The problem actually went away on it's own believe it or not. I drove it to the Oregon shindig from t; /html/healeys/2006-01/msg00633.html (9,892 bytes)
5. Re: Problems with a Smitty BN1 installation (score: 1): Author: Dave & M <rusd@velocitus.net>; Date: Thu, 19 Jan 2006 10:50:05 -0700; Hi Tracy, You may very well be on to the problem. A thin disc would allow the pressure plate release fingers to set higher, closer to the throw out bearing. A thicker disc would cause the fingers to; /html/healeys/2006-01/msg00644.html (8,174 bytes)
6. Re: Problems with a Smitty BN1 installation (score: 1): Author: Eric (Rick) Wilkins <wilko2@cox.net>; Date: Thu, 19 Jan 2006 11:25:14 -0800; I seem to remember reading the install instructions a while back, and shortening the clutch slave pushrod was one of the items... Wilko San Diego; /html/healeys/2006-01/msg00649.html (7,060 bytes)

Current List: 1 - 6
Page: [1]