Tom,
Dick Taylor had a couple good suggestions. You might also check out:
http://www.buckeyetriumphs.org/technical/Brakes/Pedal/Pedal.htm
Nelson
----- Original Message -----
From: "Tom Bottman" <tombotts@qwest.net>
To: <6pack@autox.team.net>
Sent: Saturday, May 11, 2002 7:14 PM
Subject: Clutch Master Cyl pushrod x-mac-creator="4D4F5353"
> Have been having increasing problems disengaging the clutch on my 74
> TR6.
> Took the clues from a recent posting and looked at all the connections
> from
> pushrod to pedal, etc.
> Found a great deal of wear on the clutch master cylinder pushrod - oval
> holes instead of round. Figure I am losing about 1/4".
> However, just found that the big three suppliers do not carry this item!
>
> Any suggestions?
> Thanks,
> Tom Bottman
|